What fluid goes in a g56 transmission?

How much fluid does a G56 transmission hold?

The fluid capacity for the G56 is supposed to be 6 quarts and 2 quarts for the transfer case (NV273).

What fluid do I put in my manual transmission?

Commonly recommended manual transmission fluid formulations include SAE 80W, 75W-90, 80W-90 and SAE 90. In some cases, a multi-grade engine oil or automatic transmission fluid may be recommended. However, a manual transmission fluid is typically the most optimal for manual transmissions.

Is the G56 a good transmission?

The G56 is a good trans and quiet with stock clutch, tried many fluids in mine and with stock clutch the amsoil mtg is the smoothest best fluid in my experience. Many options for aftermarket clutches which will make it louder in certain situations.

Where is the fill hole on a G56 transmission?

The Fill hole is located on the passenger side of the transmission, and it is still in its original spot.

Who makes the G56 transmission?

G56 Transmission Overview

Manufactured in Brazil by Mercedes-Benz, the G56 transmission is a 6-speed manual transmission that was designed specifically for light and medium duty diesel trucks.

IT\'S FUNNING:  Frequent question: Why did Tesla choose electric cars?

Which is better NV5600 or G56?

The single advantage to the NV5600 is the higher OD ratio than the G56 in the pre-emission years. Some say there isn’t enough main shaft supports and the aluminum case flexes too much on the G56 when used hard. The NV5600 is heavy and requires oil changes often, IMO at 20K miles, as it shears it’s oil down.

What kind of fluid does a NV5600 take?

The NV5600 takes a special lubricant, not gear oil. The Mopar part number is 4874464. Transmissions specific 5W30. 5W30 motor oil is not recommended.

What fluid does NV3500 take?

Lubricants for the NV3500: OEM Recommended: Mopar Manual Transmission Lubricant (4874464) GM Synchromesh Transmission Fluid (in US 12377916 in Canada 10953465)

Is it OK to put ATF in a manual transmission?

Yes – provided the original equipment manufacturer recommends it. It’s important to check your owner’s manual to make sure before dumping ATF in your manual transmission. In fact, some manuals may call for a gear lube or even a motor oil in older units.

Will ATF work in a manual transmission?

If you drive a vehicle with a stick shift, you might wonder if automatic transmission fluid will work in your manual transmission. … You might wonder if you can use Dextron-III/Ford Mercon multipurpose automatic transmission (ATF) instead of motor oil. The answer is a qualified, “Yes.”

Is there a difference between automatic transmission fluid and manual transmission fluid?

Automatic transmissions use pressurized fluid to change gears. Automatic transmission fluid is hydraulic fluid. … That’s one reason automatic transmission fluid has a lower viscosity than manual transmission fluid. Fluid that has accumulated foam can also fail in its role as a hydraulic fluid.

IT\'S FUNNING:  Best answer: Can you add a warranty to a used car?

How much does it cost to rebuild a G56 transmission?

Rebuilt Dyno Tested G56 Transmissions 12 month warranty

Part Number Description Your Cost
MTCRY029 Rebuilt Transmission 05-UP 4X2 $5,193.33
MTCRY030 Rebuilt Transmission 05-UP 4X4 $5,193.33
MTCRY028 Rebuilt Transmission 05-UP 4X4 $5,193.33
Core Charge on above Transmission $2,000.00

What years did the G56 come in?

The G56 was first used in the ’06+ model trucks. A 2005 will still have the NV5600.

Is G56 better than 68RFE?

Many people love the transmission and say the power difference is not noticeable and if you plan to delete and tune there is no difference except you will need a clutch but the g56 with a clutch can handle more power than the 68rfe.