What temp is too high for transmission?
Fluid Life Expectancy vs Temperature
The ideal operating temperature of transmission fluid is 175 degrees. Overheating occurs after the temperature surpasses 200 degrees, and the failure rate doubles for every additional 20 degree increase after that.
What is a healthy transmission temperature?
Normal operating temperature for an automatic transmission is about the same as the engine temperature, i.e., about 195°F. The temperature inside the torque converter, while pulling a big load from a standing start, could easily rise above 350°F. Fluid breakdown often results in harsh shifting and slip-bump concerns.
Is 180 too hot for a transmission?
So, this manual indicates that the normal automatic transmission oil temperature range is 180F – 200F. If you have a temperature gauge on your transmission oil and find that it exceeds those numbers you should be adding an extra transmission oil cooler to your vehicle.
How do I lower my transmission temperature?
Tips and Tricks to Cool a Transmission
- Use an Additive. One of the simplest things you can do to keep your transmission cool and extend its life is to use a transmission fluid additive on a regular basis. …
- Go Neutral. …
- External Coolers.
Is 200 degrees hot for a transmission?
The ideal temperature for your transmission is 200 degrees. For every 20 degrees past 200, the lifespan of your transmission is reduced by a factor of 2. In other words, if you hit 220 degrees, you can expect to get about half the normal life out of your transmission. … Hot transmissions give off an odor.
What is a bad temperature for a transmission?
#1 Cause of Failure
The optimal temperature range for transmission fluid is 175 to 220 degrees. Above that, for every 20 degrees bad things happen, starting with formation of varnish at 240 degrees, followed by seals hardening, plates slipping, seals and clutches burn out, carbon is formed, and, ultimately, failure.
What is a low transmission temperature?
The ideal temperature for it is 175 degrees, plus or minus 25 degrees, and when the transmission gets below zero degrees, it gets too thick. The fluid can also fail to lubricate parts when it is too cold, wearing parts down unnecessarily.
How do I check my transmission temperature?
Install the scan tool, start the vehicle and look for the transmission temperature. The fluid temperature should be between the 185- and 194-degree marks with an idle of 600 to 800 rpms. Remove the bolts and clips from the front fender well on the driver’s side, and locate the transmission fill plug; remove it.
What is too hot for an Allison transmission?
Temperatures from 230-240 have been reached with no damage to the transmission. If you are seeing temps above 225 degrees on a regular basis you should check your fluid level. Fluid levels to high may cause excessive temperature. … These transmissions will run from 200-230 in the summer months when towing in hilly areas.
Is 185 to hot for a transmission?
Since automatic transmissions are located closer to the middle of the car, how do you know when your gears are running a little too hot? … A transmission operating temperature normally tends to be anywhere from 175 to 200 degrees, with the fluid inside ranging between 185-194 degrees Fahrenheit.
What temperature does a transmission run?
Normal transmission fluid temperature is about 160-175 degrees. It might rise as high as 200-220 degrees under demanding conditions but hopefully it won’t go any higher.